L297 L298 Stepper Motor Drivers For Mac

Posted on by

This module can drive either 2 DC motors or 1 Stepper motor at a time.

L297 l298 stepper motor drivers for mac downloadStepper

This module is based on L298N,high voltage,high current dual full bridge driver which can be used to drive a DC motor and stepper motor, relay coil inductive load; using standard logic level signal control; having two enable control end allow or prohibit the work has a logic device power supply input terminal, in the case regardless of the input signal affect the internal logic circuit portion to operate at a low voltage; can be an external sense resistor, the amount of change in feedback to the control circuit.

This module integrates a built-in 5V power supply. When you drive voltage of 7V-35V can onboard 5V logic supply, do not input voltage when using onboard 5V power supply, the +5 V power supply interface, but leads to 5V voltage for external use
When ENA is HIGH, IN1 IN2 control OUT1 OUT2
When ENB is HIGH, IN3 IN4 control OUT3 OUT4


You don’t have to spend a lot of money to control motors with an Arduino or compatible board. After some hunting around we found a neat motor control module based on the L298N H-bridge IC that can allows you to control the speed and direction of two DC motors, or control one bipolar stepper motor with ease. The L298N H-bridge module can be used with motors that have a voltage of between 5. The L297 Stepper Motor Controller is primarily intended for use with an L298N or L293E bridge driver in stepper motor driving applications. It receives control signals from the system’s controller, usually a microcomputer chip, and provides all the nec-essary drive signals for the power stage. Stepper Motor Driver using L298 and L297 For additional stepper motor drivers see the Links below. Click the image to enlarge. This Stepper motor controller uses the L297 and L298N driver combination; it can be used as stand alone or controlled by microcontroller. It is designed to accept step pulses at up to 25,000 per second.

For

Application:

L297 L298 Stepper Motor Drivers For Mac And Cheese

L297 l298 stepper motor drivers for mac and cheese


1: driving stepper motor

L297 L298 Stepper Motor Drivers For Mac Free

2: driving brushed DC motor motor

L297 l298 stepper motor drivers for mac and cheese


Similar DC motor drivers made by techshopbd-

  • TB6612FNG Dual DC motor Controller (click here)
  • L293D Dual DC motor Controller (click here)
  • L298 Dual DC motor Controller (click here)
  • L298 Dual DC motor Shield (click here)